Christoph Nowaczek 28-10-2024 Top Gerät! Funktioniert einwandfrei!
TrimPro's Jack Puck press, with its 2 tons of pressure, is the perfect accessory for pressing and compacting our cannabis resin extraction powder into convenient blocks.
The Jack Puck press consists of a 11.4 x 11.4 x 29.2cm body to be placed on a stable, flat surface for optimal operation. This hydraulic press is easy to use. It has a removable mould that can be heated in the oven to facilitate the pressing of our raw material.
How to use the 2 Ton Jack Puck press
To use it simply unscrew the upper part to access the two-part mould, which we can place in the oven to heat up to a maximum of 100ºC.
Once heated, we first place the lower part of the mould into the base of the press, after having covered it with anti-adhesive paper, which we recommend to prevent resin sticking to the metal with the effect of heat and pressure.
Next, we will pour in the contents to press and cover with paper before replacing the flat, upper part of the mould. Then replace the screws of the upper part of the press and it's ready to start pressing.
To activate the press, the release valve, which is located on the lower part of the press, must be closed by turning it fully clockwise. Then we will move the bar up and down until we reach maximum pressure.
To recover our resin simply open the release valve by turning it anti-clockwise. Then remove the screws to access the mould. We can use the hydraulic piston to remove the pressed resin puck, by closing the valve again and giving a few pumps to lift it a few millimetres clear.
Trimpro 2 Tons Jack Puck Press info:
- Dimensions: 11.4 x 11.4 x 29.2cm
- Mould diameter: 3.17cm
- Mould height: 6.35cm
- Box size: 12.7 x 12.7 x 33 cm
